Surface Grinding wheel split method

Flange is cast iron, do not take things knock. Above demolition dedicated thread, with a special catch, under the roof, such as no dedicated arrested, according to a special thread size car.  Polycrystalline diamond catch is cup-shaped, the hole can only put the spindle axis head, cup extraoral thread by removing dedicated thread size car. bottom of the cup with a top wire, must take the cup extraoral screwed full deduction, then the top wire top. probably did not wipe the oil installation, very tight. should be installed in cone rubbed a thin layer of oil. could not butter.
Look at your problem, put the wheel on the Chuangzai Remove the screw from coming. Grinding wheel should be able to take off, with no tight as is the demolition of high, even removed along with the flange, flange on the plate, crushing wheel I do not  Synthetic diamond  all wheel Remove the screws. dismantle wrong, it is not likely to cause a split screw down. diagonal graded to loosen. could not loosen the screw once when installed, too.
If not split down the wheel screw, replace the screw and tighten. Demolished by the above method, such as not enough, drill out the screw head, then take the screws, not stretched fresh, and easy to remove. Impossible to screw replaced, so difficult to remove. turnbuckles butter.
To remove the wheel flange, and put wheel, find static equilibrium, and put on. Chuangzai can not directly change the wheel.